[ Post a Response | GatChat, Gatling Gun Discussion Forum ]

Re: Elevating screw

Posted by Steve on 6/9/2008, 8:42 am, in reply to "Re: Elevating screw"
217.159.124.90

Thanks again Dave, I'll make mine 0.225 O/D x 20 TPI Acme. As Columbo would say, 'just one more question'; What does the tee handle on the side of the carriage near the elevating wheel do? Does it screw in or is it a spring loaded plunger? Thanks, Steve

---

Message Thread: Elevating screw - Steve 6/8/2008, 2:24 am Re: Elevating screw - Dave Boles 6/8/2008, 10:34 am Re: Elevating screw - Steve 6/8/2008, 11:23 am Re: Elevating screw - Dave 6/8/2008, 4:50 pm Re: Elevating screw - Steve 6/9/2008, 8:42 am Re: Elevating screw - Dave 6/9/2008, 1:38 pm Re: Elevating screw - Steve 6/10/2008, 12:44 pm Re: Elevating screw - hammer 6/11/2008, 9:31 pm Re: Elevating screw - Steve 6/12/2008, 3:58 pm « Back to thread

---

Post a Response