Every now and then, we get someone who can not figure out why they are not getting water coming out of their wand jets, when on "the last job", they were getting normal pressure at the wand. Is there something wrong with my pump, they ask?
Probably not.
Always make sure that your female and male brass QD's are a manufacturer match brand! Because if one looks closely (and most of all knows what they are looking at) the internals (shut-off) are much different and will not at times, open the water flow. Further, the internal o-rings will sometimes dislodge and clog the flow.
My advice to avoid a shut-down on location, is to always double check whenever you want to use a particular tool not purchased through us. These D's are copy-cats of the good ones.
Sounds familiar!--lol!
Message Thread
« Back to index
The JAGUAR MX-2 ETM @ cross-american.com