(Barrels from Dave Burnett)
First I turned the end back .375 to .390 dia, & bored the chambers,cut the slot for the extractors per print.
next cut two slots .187 wide by .05 deep, .125 from the shoulder, parallel to extractor slot.
Bored the holes in the plate for slip fit (.390 dia) & milled extractor slots. On the same bolt circle between
the bores I drill & c'bore for mounting screws.Then I made some wedge clamps, with minimum clearance.
Now I have enough rotation to line up slots with a gage block and lock in place. No hex required.
Message Thread
« Back to index