Your DMX512 Problems: Re: Problem generating correct DMX(?)

Your DMX512 Problems
[ Post a Response | Your DMX512 Problems ]

Re: Problem generating correct DMX(?)

Posted by HÃ¥kon on 8/2/2009, 11:10 pm, in reply to "Re: Problem generating correct DMX(?)"

Hi,

It's a Martin Robocolor PRO 400.

The manual says that values over 252 is "Lamp off", but only in "MODE 3" which is set by a dip switch internally in the fixture. The default mode should be 1, which I would guess it is. I would think that even though it was set to Mode 3, I would hear the fixture change the other things like the gobo/colors etc, when it got a valid signal?3

Message Thread

Problem generating correct DMX(?) - Håkon 8/2/2009, 10:27 pm

Re: Problem generating correct DMX(?) - chris 8/11/2009, 5:34 pm
- Re: Problem generating correct DMX(?) - HÃ¥kon 8/12/2009, 1:48 am
Re: Problem generating correct DMX(?) - Ujjal 8/2/2009, 11:02 pm
- Re: Problem generating correct DMX(?) - HÃ¥kon 8/2/2009, 11:10 pm

« Back to index

Post a Response

Hosted for FREE by Boardhost.
Create your own free message board!