Re: Hydrotek 1114 -- replacement

Posted by Denise on 10/4/2006, 2:29 pm, in reply to "Re: Hydrotek 1114 -- replacement "
74.236.113.228

Hey, Have you had any luck locating those Hydrotek replacement pins? I tried using some JB Weld on my timer hoping that it would work because I haven't been able to locate them either. It just made a huge mess. Apparently the location of the sprinkler timer was too hot for the JB Weld to set properly. UGH... this is frustrating.

---

Message Thread: Hydrotek 1114 -- replacement pin - mayra 4/22/2005, 10:38 am Re: Hydrotek 1114 -- replacement pin - Jim Ruttenberg 2/15/2009, 6:03 pm Re: Hydrotek 1114 -- replacement pin - Bob Ingham 4/28/2009, 2:50 pm Re: Hydrotek 1114 -- automatice use - Toni 2/23/2007, 5:12 am Re: Hydrotek 1114 -- automatice use - jack wojnarek 7/25/2009, 10:14 am Re: Hydrotek 1114 -- replacement pin - Denise 10/4/2006, 2:44 pm Re: Hydrotek 1114 -- replacement pin - Jiuan Jen Jong 3/17/2006, 7:26 pm Re: Hydrotek 1114 -- replacement - Brian 1/30/2006, 3:58 pm Re: Hydrotek 1114 -- replacement - Denise 10/4/2006, 2:29 pm Re: Hydrotek 1114 -- replacement pin - Ryan 4/26/2005, 11:39 am Re: Hydrotek 1114 -- replacement pin - patty 8/21/2005, 7:10 am « Back to thread

---

Post a Response