Posted by Grassy Creek Mill
![]()
on 2/13/2005, 6:07 am, in reply to "Re: Water Wheel Bearings"
151.213.114.236
Henry,
Thanks for the response, Sorry for the long delay have been off in many other directions. Hope to be back here for a while. Yes I still need bearings. They need to be split bearings, for 3" dia. shaft and I do have the bottom half of one. It is cast iron,babbit filled, with four bolts holding the top half and two slots for bolts to mount it. I do have a drawing of both halves that I could send. Can I e-mail it or send it us postal service?
tom
Message Thread:
![]()
« Back to thread