Listed are the items I have either completed or partially completed for the RG-G Gatling gun from plans purchased in 1991. I am a machinist by trade. All of the parts are well within tolerance and good finishes. I’m hoping to sell this as a lot for a reasonable price and perhaps speed up someone’s project. I started this project many years ago and just lost interest. If you e-mail me, I’ll send you a bunch of photos of the items listed below.
1. 12 completed extractors (not yet case hardened)
2. 10 cam followers that just need to be turned to length.
3. 10 barrel liners purchased from Brownells.
4. 10 mechanical tubing for barrels
5. 10 completed bolt plugs
6. 10 completed hammer shafts
7. 10 bolts, all lathe work and threading done. Needs milling operations to complete.
8. 10 complete recoil pins
9. Ring stock for frame assembly arches. (steel)
10. Breech back plate (brass), all lathe work done. Needs milling operations to complete
11. Crank arm completed.
12. set of drive gears
13. bearings and bushings
14. Swivel Yoke cut but needs finishing. (steel)
15. Stock for steel frame rails
16. 2 brass magazine base supports cut to finished size
17. Box cam steel stock 3”O.D x 2.375 I.D. x 3” long
18. Breech casing tube stock,
19. Brass tubing stock for magazine carrier block
20. Carrier block (completed)
21. Front barrel plate (completed)
22. Rear barrel plate (complete except for dowel pin holes on periphery)
Message Thread
« Back to index