[ Post a Response | GatChat, Gatling Gun Discussion Forum ]

Re: Wanted small gatling medallion between 1" and 2"

Posted by Dick C. on 8/23/2009, 3:57 pm, in reply to "Wanted small gatling medallion between 1" and 2""
75.165.144.161

Just as a tip, if you get one of Paul's medallions, I suggest making some 'pie-jaws' for your mill vise or lathe chuck and thinning the medallion about half of its thickness. As the medallion comes flat and must be bent, after annealing the thinner piece sure bends easier and with much less danger of cracking, and also looks better on the breech case. Dick

---

Message Thread: Wanted small gatling medallion between 1" and 2" - mike 8/18/2009, 7:56 pm Re: Wanted small gatling medallion between 1" and 2" - Dave Boles 8/19/2009, 4:22 pm Re: Wanted small gatling medallion between 1" and 2" - mike 8/19/2009, 5:02 pm Re: Wanted small gatling medallion between 1" and 2" - Dennis 8/22/2009, 1:06 pm Re: Wanted small gatling medallion between 1" and 2" - Mike 8/23/2009, 7:59 pm Re: Wanted small gatling medallion between 1" and 2" - Dennis 8/24/2009, 3:29 pm Re: Wanted small gatling medallion between 1" and 2" - Dick C. 8/23/2009, 3:57 pm Re: Wanted small gatling medallion between 1" and 2" - mike 8/23/2009, 7:57 pm Re: Wanted small gatling medallion between 1" and 2" - Dick C. 8/24/2009, 12:20 pm Re: Wanted small gatling medallion between 1" and 2" - Dennis 8/27/2009, 2:17 pm Re: Wanted small gatling medallion between 1" and 2" - fred 8/28/2009, 5:25 pm « Back to thread

---

Post a Response