For everyone's information and Charlie's list.
I am at the stage of fitting the cam into the receiver tube, and making and fitting the side rails. In drawings 48-09 and 48-09 A I have found something that needs altering in future, as well as the "Left View" center line correction.
In "Detail A" the first vertical hole (from the rear or right of the drawing) to mount the frame rails to the brass receiver side rails is shown as being 1.000" from the end. In the "Sectional View From Top" drawing below this, this rear mounting hole is drawn REARWARD of the recoil plate position (set into the receiver by 0.950") and only at 0.750" from the end. This would not work as the front of the drive shaft lug is also at 0.750"! I am assuming the hole in the lower drawing is just drawn in the wrong place, and dimensions as per plan (ie 1.000" from the end) will be OK as it is then well in front of the drive shaft lug and will therefore drill into the rear of the main frame, and will clear the rear side rail mounting screw.
Message Thread
« Back to index