[ Post a Response | GatChat, Gatling Gun Discussion Forum ]
Posted by Dick C.
on 12/18/2007, 9:35 am, in reply to "Where to start?"
207.200.116.71
Get your barrels reamed and the liners installed, either soldered or epoxied; cut them to length, thread them, crown them, and cut and finish sand the hexes. You'll feel a whole lot better and have one of the tedious jobs done. Then do the carrier block and the front and rear plates, then you can screw the barrels in temporarily and stand back and behold: its started to look like a Gatling Gun!
Well, that's my take, over.
Dick C.
Message Thread:
« Back to thread