[ Post a Response | GatChat, Gatling Gun Discussion Forum ]
Posted by John M. Hess
on 4/15/2007, 8:58 am, in reply to "most difficult part?"
64.12.116.70
I tried to reduce any difficulty on a tripod yoke. I programmed to cut the yoke out of one solid piece of brass. I contoured the top to look like trunnion hinges. Then drilled and reamed for a .500" shoulder bolt to screw into the side rails. I turned the heads down and pressed a decorative knob on the end. The customer was very pleased with the way it looked. If anyone wants to see it I can e-mail photos.
Message Thread:
« Back to thread