[ Post a Response | GatChat, Gatling Gun Discussion Forum ]
Posted by Gary Nelson Thanks for your help
on 1/22/2007, 6:45 pm
24.118.10.14
A question about part C on drawing 5300. Is the 15/32 ream size correct? If the hole is reamed to 15/32 (.468) it will cut into the 1/2-32 thread. The minor dia. of a 1/2-32 thread is.462.
Another question on the same part. Is the .281 flat milled across the entire length of the part or just a portion of it?
Message Thread:
« Back to thread