[ Post a Response | GatChat, Gatling Gun Discussion Forum ]
Posted by Fred on 10/10/2006, 1:19 pm Sorry for the excessive questions but alot of the lines didn't reproduce very well on my set of drawings.
66.142.171.224
Another dumb question on Dwg 48-30 concerning the hole location for the pivot pin.
On the magazine body it is .085 off the edge and .625 from the end.
On the extractor it is .625 from the end but how far from the edge. When the long taper is cut on the extractor it looks like it would cut into the pivot hole if the .085 dimension is used there also. Thanks
Message Thread:
« Back to thread