[ Post a Response | GatChat, Gatling Gun Discussion Forum ]
Posted by gerry
on 9/20/2006, 4:58 am
65.164.153.153
i jjust finished putting the slot in the shaft when i realized its perpendicular to the flats of the hex, not as shown in the print, do i have to make again or will this not affect operation? also the directions for that page call for a spacer tube to be milled to length as in drawing but the print doesnt show any tube on that page? thanks for your help. i'm finally getting started on these after getting the prints about 4 years ago.
Message Thread:
« Back to thread