Write the IDLE, BREAK or MAB code.

Posted by Chilin Cheng on 7/9/2007, 6:11 pm
219.71.208.196

Hi Ujjal and Guys, I am trying to use Atmel AT89C51 MCU , run at 24Mhz, UART mode3 to program DMX512 signal format. But I don¡¦t know how to write the code to transmission the IDLE, BREAK and MAB code. Could anyone can tell me how to write the correct assemble or c code? Thank you very. Chilin Cheng 07/01/2007

---

Message Thread: Write the IDLE, BREAK or MAB code. - Chilin Cheng 7/9/2007, 6:11 pm Re: Write the IDLE, BREAK or MAB code. - Ujjal 7/12/2007, 9:17 pm Re: Write the IDLE, BREAK or MAB code. - Ujjal 7/12/2007, 9:23 pm Re: Write the IDLE, BREAK or MAB code. - Chilin Cheng 7/15/2007, 10:56 am « Back to thread

---

Post a Response