[ POST YOUR REPLY | . ]
QUESTIONS WITHOUT EMAIL ADDRESS MAY VANISH!
Re: ACRYLIC DRILLING?
Posted by Tim on 1/10/2006, 4:24 pm, in reply to "ACRYLIC DRILLING?"
mark the shell with low tack tape. place a dot on the tape exactly where the hole should be drilled. Start the hole with a brad point bit. Then finish the hole with a Uni bit. Be very careful, you only get on chance with acrylic.
AMERICAN MUSIC DRUMPARTS & RIOLO CUSTOM DRUM
DISTINGUISHED DRUMPARTS FOR BUILDER'SWWW.AMDRUMPARTS.COM
Hosted for FREE by Boardhost.
Create your own free message board!