Posted by Don on December 19, 2008, 4:30 pm, in reply to "CS convertable end cap installation"
162.74.70.193
Your correct, the glue is what's holding it in place. You will need to use glue as well or the water will follow the cracks and lean on your lap on the inside. I believe 3m makes the glue your looking for.
--Previous Message--
: Im replacing my end caps on my convertable,
: one pillar trim piece and weather strip for
: the pillar. My question is once I get the
: screws off the pillar trim and the end cap
: what else is keeping them attached? I think
: its just some kind of adhesive glue. Am I
: correct? Do I just pull on the parts to
: release them? And when I install the new
: parts Do I use silicone to replace the glue?
: How about the pillar weather strip, what
: keeps it in place? thanks for any help
:
Message Thread:
« Back to thread