Posted by John on July 18, 2007, 11:47 am, in reply to "Re: trunk torsion bars" --Previous Message--
68.81.67.105
Dave, Contact Bob @ W30442Bob@aol.com he had a pair from a car he was parting out. It appears that you may have to make a tool that will give you enough leverage to get the bar in place. I have not done mine as of yet. Good Luck!
: No help on putting them in. Can I asked where
: you found replacements? One of mine snapped
: this weekend.
:
: --Previous Message--
: I am replacing the torsion bars that support
: the trunk lid in my 67 CS Conv. I managed
: to get one in but the second one is not
: going very easily. Any one done this before
: and any words of wisdom would be
: appreciated. Thanks.
:
:
:
Message Thread:
« Back to thread